Construction parameters of Chlorinated rubber primer
- Author:
- Origin:
- Time of issue:2022-11-09 09:44
- Views:
Summary:1. Surface treatment of Chlorinated rubber primer is sand blasting and shot blasting to remove oxide scale, rust, and oil, up to Sa2.5 or St3. The substrate temperature of the Chlorinated rubber primer is 3°C higher than the dew point.
Construction parameters of Chlorinated rubber primer
(Summary description)1. Surface treatment of Chlorinated rubber primer is sand blasting and shot blasting to remove oxide scale, rust, and oil, up to Sa2.5 or St3. The substrate temperature of the Chlorinated rubber primer is 3°C higher than the dew point.
- Categories:News
- Author:
- Origin:
- Time of issue:2022-11-09 09:44
- Views:0
1. Surface treatment of Chlorinated rubber primer is sand blasting and shot blasting to remove oxide scale, rust, and oil, up to Sa2.5 or St3. The substrate temperature of the Chlorinated rubber primer is 3°C higher than the dew point.
2. Coating method of Chlorinated rubber primer is brush, roller, spray, high pressure airless spray. Thinner: Adjust the chlorinated rubber paint thinner to the appropriate viscosity.
3. Coating thickness of Chlorinated rubber primer is 2 coats, dry film thickness of 60-80um. Overcoating interval: about 12 hours at 25℃. Post-matching paint: chlorinated rubber enamel, acrylic enamel.
Notes of Chlorinated rubber primer. 1. The construction site should have good ventilation facilities. 2. Construction workers should wear masks, glasses, gloves, and other protective equipment to avoid skin contact and inhalation of paint mist and solvents. 3. Smoking is strictly prohibited on the construction site, and all sources of ignition are isolated.
Through the above introduction and analysis of the Construction parameters of Chlorinated rubber primer, hope it helps you.
Scan the QR code to read on your phone