Product Series
Epoxy Engineering Floor Paint (Double Group)
Construction method:Rolling, scraping, spraying (correct construction method according to construction process requirements)
Basic Ground Treatment:
1. When constructing on new concrete ground, it must be cured on the ground for more than 25 days before construction.
2. Remove loose plaster and oil stains on the ground. If there are gaps, repair them in time to ensure that the ground is flat, clean and dry.
3. When recoating the ground, it is necessary to remove the weak paint film of the old ground, remove the dust and sundries on the surface, grind it flat, clean and thoroughly remove the dust. In order to ensure the quality of the coating, the concrete grade of the construction ground must be above C25.
Coating preparation: After opening the bucket, stir it evenly, then pour the A and B groups into the mixing bucket according to the proportion, and fully mix with a mixer for 3-5 minutes.
In order to achieve the best painting effect, no diluting material should be added when painting. If the paint is thick, it can be diluted with no more than 5% of the special diluting material according to the actual situation.
Construction process:
Ground treatment: sanding the ground, repairing defects, cleaning and drying
Roller coating engineering floor primer
Use the engineering floor intermediate coating material to prepare the quartz sand to the required thickness for construction (recommended A:B:sand=4:1:5)
Use the engineering floor intermediate coating material to prepare the quartz powder to scrape the putty layer (recommended A:B:powder=4:1:2.5)
Roll or spray engineering floor topcoat materials, and the thickness of one film is not more than 100μm.
Construction Conditions:
The moisture content of the construction ground is required to be below 8%, and construction should be avoided on cloudy and rainy days or when the relative humidity of the atmosphere is higher than 80%, or when the temperature is below 5°C and above 35°C.
Note: The prepared materials must be painted within 30 minutes, and the prepared materials must be discarded after 30 minutes.
Curing time: 7 days / 25 ℃, the low temperature (not lower than 5 ℃) should be properly extended to obtain the ideal coating effect.
Storage and storage: Sealed and stored in a cool, ventilated and dry place at 5-35°C, moisture-proof and sun-proof, away from fire, the storage period is 180 days.
Note: To ensure product quality, the suggestions and information provided above come from our independent laboratory and are accurate under controllable conditions, but since we cannot carry out direct and continuous control during the use of the product, so Regardless of whether the provided suggestions, recommended schemes and materials are adopted, our company does not bear all kinds of direct or indirect responsibilities caused by the use of the product. When constructing, please take a small area sample and confirm that it conforms to the local climate (temperature, humidity). Large-scale construction is possible.
|
Experimental Project |
Units |
Metrics |
|
|
Adhesion (cross-cut method) ) |
grade |
≤ 2 |
|
|
Shock Resistant |
Kg.cm |
50 |
|
|
Pencil Hardness |
-- |
≥ 2H |
|
|
Drying time |
Table stem |
h |
≤ 4 |
|
Work hard |
h |
≤ 24 |
|
|
Wearability (750g/500r) |
g |
≤ 0.03 |
|
|
Water resistance |
10days |
No change |
|
|
resistant 3%Saline |
10days |
No change |
|
|
resistant10%NaOH |
10days |
No change |
|
|
All tests (except drying time) are in standard Cured under conditions7Days later |
|||
